Hand-reloading requires repetitive grasping of cases. Small diameter cases are particularly difficult to hold. The issue is compounded by lubricants requiring more grip force. Add arthritis to the equation and the results are hands down a pain-in-the-brass!

Stop that pain-in-the-brass with our new Case Holder. Secure a wide range of cases for primer pocket work (head-facing) and, for most rimless cases, case mouth work (neck-facing). This tool accepts hundreds of cartridges thanks to a wide range of collets. The Case Holder design allows for reduced hand tightening to engage the collet. The protrusion* of casing can be set by an internal adjustable backstop.

*Cases shorter than 1.5” do not contact Backstop.

Collets sold separately. Not compatible with CheyTac and BMG cases.

Store collets in a Collet Block, sold separately

Tool Setup

1. Install appropriate collet by removing locking Cap
2. Adjust Backstop with flat head screwdriver to set case protrusion* *Cases shorter than 1.5” do not contact backstop

Instructions for Use

• Install cartridge into collet, twist locking Cap to secure cartridge
• Perform operation(s) as normal (except without hand fatigue)
• Twist Locking Cap to remove the case and repeat

Notes:

• Lightly oil collets for enhanced corrosion protection
• Periodically lube threads for smooth operation
• Coming Soon: Backstop for short-cases and a storage Case