Bushings (For Sizing Dies)
Spud says... "The easiest and best way to work out the bushing size you require is to get a loaded round. Measure halfway down the neck on the outside, take a measurement and then spin the case through 90 degrees to get a good average. Once we have this number, subtract .002" to get to your correct bushing size. I have found through testing that two thou under is preferred. I find .003" too tight and .001 not tight enough."
WILSON, REDDING, HORNADY, AND RCBS BUSHINGS WILL FIT EACH OTHER'S DIES; FORSTER IS BRAND-SPECIFIC AND WILL ONLY FIT FORSTER DIES